Oggetto acquistato: "1x New 1602 LCD Board Keypad Shield Blue Backlight For Arduino Duemilanove Robot"
Costo: EUR 5,37 spedito dalla cina
Cercando in rete, ho scoperto che si tratta di un clone del LCD Shield DFROBOT.
Quando mi è arrivato mi sono reso conto di avere fatto benissimo a prendere un oggetto già costruito per lo scopo, perché costo a parte (comprando i componenti e assemblando avrei speso di più) è carina la soluzione che hanno trovato per il tastierino: viene usato un solo "filo", l'ingresso analogico 0, i tasti sono "mappati" usando delle resistenze.
Codice di test (libreria standard LiquidCrystal.h - compilato con Arduino IDE 1.0 su Ubuntu 12.04)
Codice: Seleziona tutto
//Sample using LiquidCrystal library
#include <LiquidCrystal.h>
/*******************************************************
This program will test the LCD panel and the buttons
Mark Bramwell, July 2010
********************************************************/
// select the pins used on the LCD panel
LiquidCrystal lcd(8, 9, 4, 5, 6, 7);
// define some values used by the panel and buttons
int lcd_key = 0;
int adc_key_in = 0;
#define btnRIGHT 0
#define btnUP 1
#define btnDOWN 2
#define btnLEFT 3
#define btnSELECT 4
#define btnNONE 5
// read the buttons
int read_LCD_buttons()
{
adc_key_in = analogRead(0); // read the value from the sensor
// my buttons when read are centered at these valies: 0, 144, 329, 504, 741
// we add approx 50 to those values and check to see if we are close
if (adc_key_in > 1000) return btnNONE; // We make this the 1st option for speed reasons since it will be the most likely result
if (adc_key_in < 50) return btnRIGHT;
if (adc_key_in < 195) return btnUP;
if (adc_key_in < 380) return btnDOWN;
if (adc_key_in < 555) return btnLEFT;
if (adc_key_in < 790) return btnSELECT;
return btnNONE; // when all others fail, return this...
}
void setup()
{
lcd.begin(16, 2); // start the library
lcd.setCursor(0,0);
lcd.print("Premi un tasto"); // print a simple message
}
void loop()
{
lcd.setCursor(9,1); // move cursor to second line "1" and 9 spaces over
lcd.print(millis()/1000); // display seconds elapsed since power-up
lcd.setCursor(0,1); // move to the begining of the second line
lcd_key = read_LCD_buttons(); // read the buttons
switch (lcd_key) // depending on which button was pushed, we perform an action
{
case btnRIGHT:
{
lcd.print("DESTRA ");
break;
}
case btnLEFT:
{
lcd.print("SINISTRA");
break;
}
case btnUP:
{
lcd.print("SU ");
break;
}
case btnDOWN:
{
lcd.print("GIU ");
break;
}
case btnSELECT:
{
lcd.print("SELECT ");
break;
}
case btnNONE:
{
lcd.print("NESSUNO ");
break;
}
}
}
Links utili:
http://www.dfrobot.com/wiki/index.php?t ... :_DFR0009)